Tractor Talk Discussion Board |
Re: Ferguson hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by greg on March 11, 2001 at 18:04:21 from (168.169.144.22):
In Reply to: Ferguson hydraulics posted by Barry Gould on March 11, 2001 at 12:28:04:
Hydraulics are a wonderful thing. You must first determine if you in fact have a pump problem or other problems. I recommend 1) check fluid level. Many problems can be traced to fluid problems of some sort-level included. 2) System must have a relief valve in it. Before hooking up any gauges to check pressures, make sure you hook gauges AFTER the relief. This will tell you relief pressure setting And protect your system from damage. 3)Most loader spools have a relief built in them. Recognized by an "acorn" style locknut over an adjustment bolt. Remove hose going to lift cylinders, install gauge in this hose, move lever to lift position and read gauge. This will tell you relief setting, but make sure 1)the hose has no tee's in it because fluid pressure will go to the path of least reistance and not to your gauge,2)BE CERTAIN YOU ARE HOOKED BEYOND THE RELIEF OR IMMEDIATE PUMP DAMAGE WILL RESULT.3)DO NOT HOLD SYSTEM 'AGAINST RELIEF' FOR MORE THAN A FEW SECONDS AT A TIME AS SYSTEM DAMAGE MAY RESULT. System should develop at least 1200 psi to do much work, but service manuals will have specs. If pressure is sufficient, you may have seals in the cylinders that are bypassing oil, end result being that the path of least resistance is around the seal instead of against it (doing work). Seals bypassing is usually accompanied by the cylinders slowly drifting down (but not always). Be cautious when performing these steps, because even if you do everything right, you will still be asking these older hydraulic hoses to do a lot and may end up with an oil shower. Hope these suggestions help find your trouble.
Follow Ups:
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|