Posted by gene bender on January 21, 2010 at 03:12:50 from (67.55.226.179):
In Reply to: Fan belt replacement posted by Vern on January 20, 2010 at 21:38:07:
Any where from a 5/8 on up to 13/16 because we dont know if it is an original from here. Replacements had different sizes where the wrench goes on the shaft. The nut on the block side is not to be turned as it sitsin a slotted area and the shaft on the fan is turned. Better have a 15/16 or so to hold it from turning as it mite be screwed up from a previous owner. Replace the fan belt at this time and if someone hasnt screwed that part up also it takes a 17/32 wide buy 26 1/2 long. Have fun it can be a mess to change.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
