Posted by Lanse on December 31, 2009 at 16:07:24 from (65.89.42.234):
Hey guys :-)
Im down on the farm this week again... And ive been keeping busy getting that S10 apart...
I used the welder to get the remains of the fenders and front clip off, which finally happened, and started bending the frame back... Im not doing too good just pulling it with a chain...
Does anyone have any ideas on bending a frame?? I dont have a torch...
And then today l started trying to get my ranger running again...
Its not getting fuel, so i reset the crash switch, and put in a new relay.
It hasnt worked since I put some of that nasty orange gas in, from the radiator shop from hell...
If anyone remembers that inncident, l took a gas tank from the B to a place in dayton, and they inbred there was supposed to clean the tank and seal it...
He just charged me $100 to dump a can of redcote in there...
And it all fell out. Atleast i got most of my money back...
He said the gas I put in should be fine if i just ran it through a really fine coffee filter a couple times...
And I was dumb enough to listen.
So now I have a dead truck and a brand new carberator that the parts fairy brought me that needs to be rebuilt.
I am not happy.
As if i dont destroy enough stuff to begin with.. Looks like other people are here to help me wreck more....
Where should I start now??
Is there any way to unclog a clogged up fuel pump??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
