Posted by bc on December 18, 2009 at 23:15:29 from (69.149.214.27):
In Reply to: p.t.o. generator posted by mark from the fort on December 18, 2009 at 08:30:38:
My 2 cents. When we lose power its for a week or two with any big ice storm and the farm being on the end of the line.
Last year just before Christmas, we lost power for about a week. Was given a little Coleman 2250 watt job with a 5 hp Tecumseh. 7 years old and never had gas or oil in it. Well, the engine case splits a couple inches above the bottom. The gasket was dried out and was seeping oil. Only ran an hour before it needed refilling with gas and oil. Just used it to run a few lights, the fridge, and the propane furnace blower. Ended up just running it in the evening until the house heated up to above 90 degrees. Did the same thing again in the morning. Eventually got the gasket fixed but it still leaks and bought a new 6000 watt one that is still in the box. Bought it a Home cheapo when they finally got a new shipment in and when we got home the power crew was down to replacing the last 3 poles and so never used it.
Moral of the story is that for the little one or even the big one, there is going to be a lot of trips with gas cans to the station. No barrel at the farm. The farmers I knew with pto generators didn't want to run their tractors and put in gas/diesel 24/7 for a week either. So they did it part time as well.
If money wasn't an object, I'd put in a propane generator and hook into the main tank. They make them for natural gas too.
I wouldn't mind finding a generator and putting a pulley on it and run it off my pickup or the tractor like an alternator.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.