Posted by andy r on December 15, 2009 at 18:01:13 from (69.66.71.73):
In Reply to: JD 70 clutch stuck posted by jmducks1 on December 15, 2009 at 17:38:08:
I prefer to take my time getting the clutch unstuck. Force just breaks things. Soaking the adjusting nuts and bolts up first. Getting them loose and off. Then pulling the plates/disks and driver. Sometimes they are sort of stuck together too. Could be that the adjusting bolts are stuck in the pulley holes also so they will need soaking and more than likely the pulley will have to come off to clean everything up. You will have to pull the clutch forks out to pull the pulley off. Not a bad job. Getting the clutch driver off might be the biggest task. Well worth the time and effort when you finally feel and hear the snap of the clutch!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
