Posted by e on December 03, 2009 at 09:21:59 from (192.43.65.245):
To give you guys some background, I'm upgrading the electrical service on our farm to 400 amp. The current system comes in to a central pole, then branches out to each building. The new system will be underground and will come into the shop. From the shop, I will be running from one main panel to the barn, house, etc.
What I'm trying to determine is if I should have grounding rods for each building, or, should I run two hots, a nuetral, and a ground from each building to the main panel. My plan has been to ground each building seperatly with two 5/8" 8' rods etc etc. It feels better to me to ground as close to the point of use as possible. The distance I need to run from the main panel to each building is about 150'.
Now my other question pertains to grounding the barn. Do I need to give any special consideration to grounding a building with livestock? Would it be better to run a ground back to the main panel to minimize the potential for stray voltage?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
