Dave . Yep sent pictures to the e mail address shortly after you sent you address. Will try again tomorrow. will send 2 davnull@yahoo.com again in the morning. My e mail address will show up as sender so you can let me know if they got to you O.K. Hope my remarks on the loader usage didn"t offend you and after long consideration if it were me, with a slight depth of digging, I would use a roto tiller to loosen the soil then scoop it out if it wasn"t a big project. I"m going tomorrow to look at a O.C. crawler and from what I was told, the fan came loose and tore up the radiator, It"s gonna take a new core, turn the pins and a couple of rollers,now thats his story but I"m sure it will take additional parts and work. I had a 420 crawler years back and I had a lot of work done to it to make it a great unit. Both final drives, 1st gear ,seals and bearings in the final drives plus having the axles re welded and turnd down where the axle shaft was driffed punched to hold the bearings in place. All in all it was a great unit. Now comes around again , a place to grade off a secondary septic site and a place for the building to put equiptment in (The hidious tractor etc)for one. Wish me luck. LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
