Posted by George Marsh on November 29, 2009 at 17:01:43 from (71.114.186.110):
In Reply to: Pole shed questions. posted by gun guru on November 28, 2009 at 07:04:51:
I paid $12,000 to have a 30X40x10 pole barn build built in Indiana. Our building code required the post be buried 4 ft. My trusses are on 2 ft centers, 1 ft overhand, 1/2 osb, and shingles. Do the math, you may find it is cheaper Not to have a metal roof, not to mention with metal roof you always have the possibility of condensation and leaks. Highly recommend having side lights. Only have one 3 ft door and one 12X8 overhead door. I went with 5 1/2 in 4000 lb mix in the floor. Materials for the floor were around $3000. That included a 10X30 apron in front. Plus $500 labor for the concrete. My neighbor informed me that if I had a dirt floor, criminals would dig under the boards and break in. My bottom boards are 2x8. After it was built I spent a lot of time removing dirt from the sides and making the water run away from the building. A self leveling Dewalt rotating laser came in handy and so did my Terramite T5C.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.