Posted by gun guru on November 28, 2009 at 07:04:51 from (66.227.197.240):
I posted a message on here a week ago about pole sheds, steel vs. wood and so on.
Here are more questions.
1. I am thinking about a pole barn cause I wont have to put in a concrete foundation.
2. For those of you that have pole barns what type of floor do you have, Gravel, dirt/sand, concrete.
3. How far down does your bottom board go into the dirt? Do you use a 2x6 treated board? Should I put down a heavy visqueen vapor barrier before I put down limestone gravel for a foundation to keep moisture out?
4. How difficult is it to have all the poles line up properly and not be crooked, before you nail the siding on. I have never built a pole shed structure, but I have built 2x4 stick built frames which are easier to set up on a concrete pad.
5. If you dont have a concrete floor but have a gravel floor then how difficult or common is it to have rodents dig underneath to get into shed?
Post a picture if you can, I would like to put up a steel sided structure with steel roof.
I am thinking about a 400 square foot size, maybe 18X24 or so to store all the garden tools, lawnmower, tractor implements, paint etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoring a John Deere 2010 Diesel Tractor - by Jim Nielsen. Following seven years working in California's Silicon Valley, my wife, baby son and I moved back to Australia to retire. We bought a small 'farm' of about 50 acres near Bendigo, in the state of Victoria. I soon found that it would be very useful to have a tractor around the place for things such as grading our long drive and brush-hogging the fields. I was also embarking on planting 1000 eucalyptus trees, and hence I would need a ripper, small disk plow, sprayer etc. to get these things accompli
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
