If as 36coup suggest as a possibility, the unit has an internal problem, then all the other discussion is moot.
However, even though this has really been said, let me re-state in my words.........maybe it will register differently.
First, I want to examine this: "The house and barn are 200 feet away and the electrical panel in the barn has no ground rod currently. Also the ground and neutral connections are combined as there is no place to separate bars. It also does not change if you take out the bonding screw in the panel. It could very well be a connection problem in the ground rods, but the house still only has one rod. I know 2 other area farmers that have had the same problem and never got it corrected either."
3 wires to barn are hot(line), neutral, & ground...right?
"Ground & neutral combined with no place to separate gnd & neutral bars"
IF this is in fact the case, it has been said that it is wrong & it is wrong & it may very well be the cause of your problem. Why? Because any power drawn from the house must travel thru a loop consisting of the hot(line) to the barn, thru the load and return to the house (properly thru the neutral), but since your neutral & ground are not separated, it returns thru the ground AND neutral...note: gnd & neutral are simply in parallel. This is not good. Because any voltage drop in the neutral now shows up on the safety ground of every appliance in the barn, including all 3 grounded water heaters. IF neutral & ground were properly separated, there would be no load currents in the safety ground & I bet your shocking problem would cease.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
