Your service ground and the fence charger ground should be no less that 50 ft. apart.
Check where the charger is plugged in and make sure the hot and neutral are connected on the proper terminal screws on the receptacle. I found that problem on a neighbors electric tobacco stringer wasn"t wire correct and the machine would shock the folks laying the leaves on the conveyor. The black wire should be hot and on the bronze colored screw in the receptacle. Then go to the barn panel to see if the wires are landed correct. Then the panel in the house too. If someone made a mistake that could be the problem.
Check the voltage at the ground rods for the fence. Use a digital fence charger meter to check this. Check right on top of the rods. With the charger on the voltage on top of any of those rods should be no more that 3 hundred volts. If it"s more that"s where the problem is. Anything over 300 volts the rods aren"t enough ground and it"s going back to your house rod looking for more ground. If it"s over 300 volts add more rods until the voltage to ground is below 300 volts.
I have one charger with 11 ground rods on it. Most have 5. Depends on the soil.
Fence charger ground rods have to be replaced over time. Over time the pulse voltage pits the ground rods and loses earth connection. Ground rods for fence chargers should be 8 ft. long and spaced no less that 10 ft. apart.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
