Tractor Talk Discussion Board |
Re: Re: Re: Leaking Head Gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DAve on January 25, 2001 at 19:17:24 from (158.252.164.155):
In Reply to: Re: Re: Leaking Head Gasket posted by hay on January 21, 2001 at 08:40:13:
I can understand the leak problem. I had to do my Farmall B head twice. The head was machined flat, correct gasket,right side down, correct torque and sequence., everything. It does help to heat them up and retorque and even then it may take some run time to completely dry up. The manual say to run until hot and retorque. I even recently bought a 2nd Farmall B and the guy put a new head gasket on and I can see where it is seeping a little antifreeze out.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|