Posted by buickanddeere on October 30, 2009 at 12:15:51 from (192.75.48.150):
In Reply to: Grinder mixer posted by 4 bottem on October 30, 2009 at 05:40:24:
Why gear the motor down to 540 rpm then turn around and belt the rpms back up to 3600 or so for the mill? There would be a loss of approx 15% stepping down then stepping up again. If on single phase power it would require one 3600rpm 16HP Baldor direct coupled to the mill. Plus a 2nd 5-10HP motor with a reduction drive to spin the mixer and unloader sections. A shaft speed of 540rpm would not be required, 100-200rpm would be lots. It"s not a foolish idea by any means. If your farm is on 3 phase power then you are in a very prcatical situation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
