Tractor Talk Discussion Board |
Re: Re: Re: While on backhoes. . .
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on January 06, 2001 at 15:48:17 from (207.254.53.133):
In Reply to: Re: Re: While on backhoes. . . posted by Ken McWilliams on January 06, 2001 at 07:55:28:
Hi Ken, Well that should teach me type when I'm tired. I was reading another post that stated his use would be very little, so I was suggesting a low cost method of repair. I did not complete my thoughts on how to harden the pipe bushings or the pins. You can use common pipe for bushings by running the bushing thru a charcoal bed adding carbon to the surface, thus making the surface harder, then quenching. Them same would apply to the pins. I do agree that if pins and bushing can be bought at the approx prices you stated, then that would be a great deal and a better choice but the prices I have found were not in that price range, more like $70 for a pin and two bushings. I never checked the sources you mentioned but will. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|