|
Tractor Talk Discussion Board |
Sickle Bar information
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matt Harrington on December 04, 2000 at 09:07:25 from (170.76.19.10):
I have purchaced an IH 7' sickle bar mower that has one rear wheel for support. It is missing a few pieces which I hope I can fabricate. What goes on the end of the sickle bar to suport it? Mine appears to have what is left of a piece of wood and some type of bracket but no one around here can tell me what it looks like. Also, did a piece of wood connect the rotary crank to the cutting bar? I can't tell from pictures I have seen because they are trying to get the whole thing in and I cannot see those areas very clearly. Any help would be greatly appreciated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
