Posted by Dick L on July 27, 2009 at 12:21:49 from (72.11.21.10):
In Reply to: Re: Fuel tank liner posted by Bill in IL on July 27, 2009 at 10:00:04:
I like the Eastwood tank kit. It has all you need and instructions.
I also buy there tank liner buy the acid at the hardware. When I use my own muriatic acid I dump in a gallon and leave it over night and in the morning fill the tank with water on top of the acid and let it set a day or so. After draining and rinsing with lots of water I dump in about a pint acetone or laquier thinner which ever I have around, swish it around good and drain it out. Let it set for a few hours and dump in the liner and rotate the tank as called for in the directions. Clean, clean, clean and dry is what it takes to get the liner to stick every where inside the tank. Funny though how well the liner sticks to dirty fingers, hands, shirts, shoes, and pants.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Piston Ring Removal and Replacement - by Chris Pratt. Piston Ring Removal and Replacement - Replacing rings is a fairly easy process to stretch the engines usability between major rebuilds and cut down on that blue smoke and high oil consumption. Frequently, replacing only the rings is not advisable because by the time you do the teardown and measurement of the components, the pistons are often beyond the manufacturers specification or something else you find will signify the need for a major rebu
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
