Posted by Mike M on July 25, 2009 at 19:41:59 from (72.251.100.76):
In Reply to: Dodge 4 x4 Vibration posted by Jeff NWOH on July 25, 2009 at 17:58:05:
I have a 1996 Dodge 4x4 now unless they change them ??? how would your front driveshaft cause a vibration as it shouldn't be turning ? unless you are going 70mph in 4x4 ? Mine has a vacume disconnect on the frt. axle and the driveshaft won't turn in 2 wd. Mine also has a constant velocity joint back by the transfer case end. I had a noise in 4x4 and the ujoints looked good but the ball between the 2 u-joints was kinda dry. New joints and a ball kit lubed up good fixed this. Might be your tires too. I have an old set of worn out Michlens and my truck always runs smoothest with them on. I had 2 other sets 1 cooper and 1 bf goodrich cheap label and neither one of those ran good.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
