Some years ago, about 10 if my memory serves me correct, "loser pays all costs" came up as a possibility in an effort to slow down or end frivolous lawsuits and ambulance chasing. It was about the time that "TORT reform" started to catch on. I recall hearing back then as an example that they do that in England, so if for instance I decide to go out on a limb and sue someone, I'd better have my ducks in a row, because if I sue and lose...I'm paying the costs of everything all the way around. Makes good sense to me, but it got shot down and blown out of the water.
The reason that it got shot down and blown out of the water was that lawyers, personal injury and other argued and lobbied like mad that a poor person that had been wronged could find themselves going up against high powered big $$$ lawyers and companies with unlimited financing and lose their shirts even more so, and in that many in our nation's rotunda are themselves lawyers, personal injury and otherwise...well, you know the outcome of that one...TORT reform, particularly that part became Dead On Arrival. OK, I'm game and can see that part of their argument, but I have to wonder what the percentages are, and since the other way clearly isn't working, it can't hurt to try what Gene suggested, and you seconded. I third it.
Much good luck and success to you and yours. Work and operate that stuff safely, and don't use road gear in the fields. Grin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.