|
Tractor Talk Discussion Board |
Re: Re: Re: Re: Re: Ignition Coils, Still Confused?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by To Harvey form Ken on November 04, 2000 at 05:04:11 from (152.163.195.213):
In Reply to: Re: Re: Re: Re: Ignition Coils, Still Confused? posted by To:. Ken McWilliams on November 03, 2000 at 20:33:56:
Harvey, Years ago when I was racing, I would use dual point distributors. (I still have one somewhere in the garage). The postion of the points assemblies would be slightly staggered to increase the dwell time, and still have large enough gap to break the circuit properly. When I tuned it, I would have to insert a piece of plastic between one set of point to hold them apart while I set the dwell on the other. Then do likewise on the other set. Back then that was the only way to get enough dwell time to saturate the ignition coil for high RPM's. Then the other problem at high speeds was point bounce. Solid state took all that away. KRM
Follow Ups:
Home
| Forums
Today's Featured Article -
Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
