|
Tractor Talk Discussion Board |
Re: brush hogging saplings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert hudson on November 03, 2000 at 13:14:09 from (208.249.71.150):
In Reply to: brush hogging saplings posted by Dale (MI) on November 02, 2000 at 19:25:26:
I find that hogging like this is as rough on the driver as the equipment. wear the safety stuff. look the land over before hogging. there might be old metal equipment hidding in there or even worse, old fence wire or cable. I once got a flat tire from running over a deer antler (5point) You can bust up good equipment in land you don't know. I agree on the tire repair agreement.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Oliver 550 Clutch Overhaul Tips - by Greg Sheppard. I got my 1964 Oliver Model 550 (serial 141-139-519) second-hand and used it for several years before the clutch began to slip. After taking up the pedal linkage several times I saw it was going to take more than that. The engine had been leaking oil at the rear seal and I suspected
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|