Posted by TexasRed on June 07, 2009 at 19:35:19 from (24.170.62.18):
Hello friends I am new to the site, But I also knew this would be the place to consult the real experts. Got a 69 model 135 from this guy and the tracor had been through a flood. right after the water went down the tractor went to the shop. All was fine with the tractor except the hydraulic system was not correct after the flood. All the rest of the tractor was OK. He let the tractor sit for 2 years and that's when I came along. Before starting the tractor I changed all the fluids, filters etc... The hydraulic system at first would lift a box blade 4 inchs off the ground then set there and pluse up and down a little. After several hours run time I looked down in the transmission fill hole and the fluid was sightly milky. Out came the fluid and was changed again. The lift is even slower that before and will not lift the box blade or nothing. it will come all the way up with no load after 1-2 minutes. I am waitng for service manuals but is there some kind of system filter that I am missing somewhere??? Please advise. Thanks Gary in Texas
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.