Hobo,NC said: (quoted from post at 18:45:23 05/21/09) I have made the swap on a few fords of that vintage,,,, I will not do one less I have the complete Donner truck,,, every thing is different on FORDS,,, you also will need the steering column ,,, a manual column will not swap to a power steering gear box are vice a versa
just swapped a 400 out for a 390 in a 77 F-350,,, bout the only thing I could use off the 400 was the power steering pump,,, even the brackets for the motor mounts that bolt to the chassis had to B swapped
I agree. It seems that there are very few parts that will interchange on a Ford. Like you said, if you're going to do an engine swap, you want the entire donor vehicle sitting handy. I swapped a 390 into a '71 that came with a 240. Even the foot accelerator pedal assembly had to be swapped out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
