If you have to bleed the fluid off to get the brake to release if it has a conventional master cylinder it sounds to me like the pushrod is not allowing the master cylinder piston to come back against the snap ring to allow the return port to open in the master cylinder. there should be a small amount of "free play" in the pedal before the pushrod starts to move the plunger in the master cylinder. Adjust the pushrod till there is a bit of play in the pushrod, so its not quite against the plunger in the cylinder. Also check the brake spring on the pedal to make sure the pedal is going to its stop. mEl
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Haying Before Tractors - by Owen Clark. Hi guys! At age 8 (1927, am now 79) I was learning how to drive a stacker team on the old homemade A-frame wooden stacker, on three of my uncles` dairy farms in Star Valley Wyoming (south of Jackson Hole, on the Wyoming-Idaho border). There was one steam tractor in the Valley, owned by an entrepeneur who used it to run his grain threshing machine, that he hauled from farm to farm for the fall harvest. We used teams of horses not only on the stacker, but on the buckrake to buck the dried
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
