|
Tractor Talk Discussion Board |
Re: mowing techniques
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve W on September 07, 2000 at 06:24:22 from (205.232.79.53):
In Reply to: mowing techniques posted by Leon Kasdorf on September 05, 2000 at 11:20:57:
All that busines is good about going around clockwise, etc, but I think your real problem, is you are steering the tractor, and not the mower. Keep in mind, that when you turn right, the mower goes left a little, and then travels outside the radius of your rear tires as it follows, creating the "lobe". I used to have the "lobe" problem, until I learned to turn sooner, by angling into the turn just a little at first, and then cutting hard later in the turn. Watch the travel of your hog, and realize it's a round spinning device, not square like it looks. Once you do this, you can minimize the lodes, and a tworst you'll have a few stray pieces of grass sticking up in the corners. Good Luck Steve
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Weldin Basics, Part 3 - by Curtis von Fange. Oxy-acetylene Welding - Part One In our series on welding we have taken a brief look at AC and DC arc welding along with basic techniques and safety equipment required for safe usage. Since our premise is to cover welding types that might best be used on a farm environment we have kept our overview purposefully simple and general. The second type of welding that this observer finds quite useful in
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|