I agree, there are different grades of them, not sure if you are going new or what, check out servis-rhino. Nice heavy duty one, if you have heavy brush cutting, you may want to stay narrow, or take half a width when cutting, that tractor should handle 6'-8' no problem, narrower for heavy brush, wider for weeds & grass. Thing is with used ones, you need to check em over thoroughly, a lot of these are just hammered, I try like heck to take good care of mine, but things happen, check to see if the seals are leaking on gear box, could dip a magnet in the case to see if there is any heavy metal particulate I suppose, also slop in the works, see if a bearing is going south etc. check for cracks and poorly done repairs/welds etc. Blades can be bent and it can be out of balance, really have to flop er over and see. Preferably you want one with a heavy duty gear box, deck etc. but really check em over, better to go new if all you can find is hammered.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
