They WILL bolt to the wheels on the BLUE tractors!!! We used them on pressed steel discs, but they would go on cast discs also! That's the reason for the flat place in the center hole, to clear the clamps on the bar axle! I am including a picture of the wheel on my 5610 with 18.4 x 30 tires, you will see 3 square holes in the disc at 12, 4 & 8 oclock. those weights should bolt on using those holes! I will agree that the weights are NOT the ONLY weights made for Fords, there are also larger diameter weights for the larger wheels, but I think that you will find that the bolt pattern is the same on both style weights!
Dave 8)
One other thought, Those weights will probably NOT work on 9, 2 & 8N's or NAA's because the discs are not equiped with holes to attach them. The pie weights attach to a disc bolted to the tractor with special lug bolts that hold the wheel on AND have a provision for the original lug bolts to thread into them to secure the pie weight disc! ( I had a set of pie weights on a '72 3000).
This post was edited by Shetland Sheepdog at 10:44:31 04/20/09 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
