|
Tractor Talk Discussion Board |
Re: SHOULD I BE PULLING UP STUMPS WITH MY TRACTOR?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Green on August 22, 2000 at 14:35:41 from (209.130.148.234):
In Reply to: SHOULD I BE PULLING UP STUMPS WITH MY TRACTOR? posted by Daniel Dickerson on August 22, 2000 at 14:00:17:
I have pulled out many stumps with my Oliver "770" row crop. The reason I mentioned row crop is that tractor for tractor , the row crop tractors seam to pull a little better than the utility models. The Oliver "770" is compareable to the international "460". Before cutting down the tree , I hook a chain to the tree about 6 or 8 feet(even higher if possible)from the ground. Pull the tree over. The leverage of being hooked high will pull the roots out of the ground. Then cut up the tree. Different trees pull harder than others , depending on how deep the roots are. Populars and evergreen trees pull easy. I pull over trees up to around 10 inches in diameter. Hard woods are limited to around 6 inches in diameter. As the tree is being pulled down , I push it off to one side with my hand. Or maybe even pull it half way , then unhook and pull from a different angle. I'm talking about live trees. Dead trees can snap in two , causeing serious injury or worse. I'm telling you how I pull over trees. I'm not in any way guiding you , the unexperianced operator , on how to pull trees over.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Roof Palomino - Tractor or Jeep? - by Steve Nelson. My father-in-law purchased this jeep-like lawn mower back in 1968. He says he paid $1600.00 for it, which was big bucks back then for a mower. My own father bought a VW bug the same year for the same price. Well it
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|