Posted by Aaron Ford on April 08, 2009 at 20:46:52 from (72.84.53.167):
Well, me and my 65...
Where to begin? The neighbor asked me to help him with some property cleanup and since it's within view of my house, I figured I would. He was removing an old above ground pool deck on a decent slope. The pool was set into the hillside. We began by pulling the front retaining wall made up of railroad ties. Then I backed down from above and pulled the deck off its supports and hauled it away. Next was to pull the 4x4s out of the ground that support the rear retaining wall. I began to drive around to pull from the area where the pool had been. The property owner asked if I could back down from above. No problem... I backed down the slope to the edge and he wrapped the chain around the post. I tensioned the chain by raising the box scraper and went to Low 1st and let out on the clutch.
That's where stuff went downhill fast.
The front end came up, I pressed the clutch and we went firing back toward the edge. I jumped on the brake, feathering the clutch, only to miss the right brake, but the left held. At this point I realized how stupid the whole thing was. What was I thinking? The rest of the job had been so easy and trouble-free that I really hadn't thought about what if something went wrong. Going backward over a 10 foot lip with no rops on top of vertical 4x4's is not my idea of how to spend a Sunday.
If I had been standing watching someone else try this I would have been the first to caution against it. What was I thinking?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
