Posted by James Howell on April 02, 2009 at 21:29:57 from (75.22.149.199):
In Reply to: Re: OT posted by MN JOE on April 02, 2009 at 16:20:34:
I agree with you completely about me learning more about the Word of God.
I recall one ordained minister's favorite quote "the largest room in any man's home is the room for improvement."
In one sermon I heard it referred to as "God's love letter" to all mankind.
I probably should read the bible at least the 4th, or is it 5th, time to make sure I have not overlooked something really important.
Try as I might, just can't seem to find the two words "God" and "hates" written together, side-by-side, in the Word of God.
Seems like an oxymoron, paradoxical, or a little out of context for the Word of God.
Kind of like referring to the operator's manual or technical manual when one of our old JD tractor's breaks down and needs repair.
I need to read the manual and follow the design engineer's instructions; sounds like a good place to start.
What sometimes concerns me is whether to read the Original John Deere manual, a re-print of the JD manual, or the aftermarket IT Manual to repair the broken down tractor.
I probably shouldn't worry so much about that, after all it is basically the same information recommended by the design engineer; just translated or written by different publishers.
One thing that we both share is our confusion about my ex-mother in law!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
