|
Tractor Talk Discussion Board |
Loose Overrunning Clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim on August 11, 2000 at 17:34:24 from (63.252.145.199):
The overrunning clutch on my Ford NAA appears to have excessive play in it. It adapts from the 1 1/8" shaft to 1 3/8". I can grab the clutch and wiggle it from side to side while installed on the shaft. I noticed it leaks grease after a several hour brush hog job.I removed the clutch and inspected it but it doesn't show any obvious signs of trouble.Is any amount of play allowable in these things? Are there any parts inside of the clutch that could wear out and cause the looseness? As always thanks for all help.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
