Tractor Talk Discussion Board |
Re: Question about cutting saplings with brush hog.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by hay on June 12, 2000 at 15:57:45 from (209.255.161.48):
In Reply to: Question about cutting saplings with brush hog. posted by Kermit on June 11, 2000 at 21:17:00:
i do commercial bush hogging with a small JD870 and a 5 ft. cutter. i always run the p.to. at recommended rpm (2600). it cuts better that way. also backing into brush is bad business because the cutter throws the debris toward you. be sure to wear protective gear(heavy pants and long sleeve shirt and hard helmet and eye protection). use common sense. if the brush looks too big, then it probably is. a chainsaw is better on the big stuff and you can cut lower to the ground so you won't have tire trouble on your next cutting. a rule i use is: if my front wheels can push over the brush you want to cut, then the cutter should handle it. if you cannot eaisly push it over then i would go with the chainsaw first. lol
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|