Old .577/.600 Nitro elephant guns for serious ivory work developed from black powder cartridges. The guns were often double barreled and weighed 16 to 20+ lbs- that is why gunbearers were used on hunts. The video shows a Mauser based short plain barrel weighing maybe 10-12 lbs? Rifleman last month had a short article on Zastavia made .50BMG based on Mauser, long barrel with 4 port muzzle brake and weighing at 35 lbs, had bipod and energy absorbing butt pad. Old WW2 Russian anti tank rifles - 2 most used Siminov was gas operated self loader that had some energy absorbing, Degtarev (sic?) was partial bolt and recoil unloading single shot- again some energy absorbing features. Feature gun could use muzzle brake and recoil absorbing butt pad or recoiling stock to be practical with lower pressure cartridge like old .577/.600 Nitro loaded with brown shutzpowder load-nitrated wood pulp- instead of guncotton and nitroglycerin Cordite. RN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
