Posted by ChrisLSD on January 30, 2009 at 06:54:41 from (71.213.210.125):
have a Deutz 7120 that has the hydraulic pump sitting on left side of tractor about starter height (attached near front of motor) I have to test it then I am thinking remove it and get it fixed/repaired - then I got to thinking - with the pump that high ....how does the oil get to the pump? does a hydraulic pump like that have enough suction to lift it from the lower tranny level through 15' of line and even during winter?
next thought - long story on what happened to this tractor but I have no 3 point at all (put the lever up and in 20 minutes with no load on the arms it will eventually raise..... no remotes.... anyway the previous owners took off a loader - removed the power beyond - then just plugged the 2 holes instead of connecting them for flow through - then the tractor sat for a year - i got to thinking that maybe the gears have broke the key on the shaft - power steering does still work for those of you deutz owners....what are the odds of this actually happening you suppose?
(Also posted this on the Allis board just in case a few more Deutz experts are there)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
WANTED Front grille/nose assembly for Massey Ferguson 1160 (also fits 1180 & 1190). Headlight-mount section. AGCO Grille 3706022M91 (supersedes 3705942M91), cover 3705494M1/M2, holders 3705501M91/3711158M92. New/NOS/good used OK. Jonesboro, AR - will pay shipping. Photo appreciated. Thanks
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
