|
Tractor Talk Discussion Board |
Re: Ford 4000- Can you help?
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by RickB. on April 27, 2000 at 15:06:38 from (205.231.149.33):
In Reply to: Ford 4000- Can you help? posted by Kevin Espy on April 25, 2000 at 20:56:19:
I see several posts from you on different boards, and no one has bothered to tell you the bleed screw on your injection pump is just above the horizontal centerline of the pump body about 2/3 of the way back from the front. It will take a 5/16" wrench. After bleeding the filter, remove this plug, Crank the engine with the fuel shutoff cable in run position. You may get fuel & air, but crank till clear fuel spurts to or beyond the front tire. Then bleed the injectors as others have instructed. Done properly, no ether or other exotic motor diets are needed. I am assuming your 4000 has the rotary CAV injection pump.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for �200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
