About a year ago we put up two sticks (20' each) of 1 1/2" pipe. Fabbed & welded an angle iron tripod with a plate welded at the top of the tripod with a pipe coupling welded also. Dug a hole in the ground and poured several bags of ready-mix to secure the foundation. Bought a big antenna from radio shack (or Walmart?) and installed the setup with four guy wires. We receive about 25 digital channels and 10 analog channels, down here in the FL panhandle. The best reception comes from stations less than 70 miles away, but we can receive stations further away. Only issue I notice is that the digital signal is highly directional and sometimes I have to adjust the direction of the antenna. My next plan is to install a [second] smaller antenna on the same mast and aim it for local channels and the larger one aimed toward more distant stations. Will tie both coaxes into a splitter.
We tried several signal amplifiers but they didn't do much and the higher gain models just distorted the signal (picture quality went down).
We used the standard coax size (I think its marked RG59?) for the leads inside and up the antenna mast. We only have one HDTV in the house so will need the converters for the others in the bedrooms until they break down or until we can afford additional HD TVs....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
