Posted by GordoSD on January 13, 2009 at 16:27:37 from (66.115.200.140):
Who is getting maximum use from their shop? I thought I'd tell you what goes on in mine besides tractor work. When I built it I had the south wall plumbed up, and a water discharge pit dug outside, Backfilled with red rock and sand for minimal use grey water discharge. So I put a washer and dryer there for really dirty shop towels, coveralls, bloody hunting pants etc.Hot water heater also. Alongside that I installed an 8 foot stainless table. And close by above a rail for hanging deer to process. Deep sink beside that. So I have a great place to process small and large game. Cabinets above hold the bags, knives, grinder, and vacumn foodsaver. Cast iron skillets,and dutch oven. I do 90% of the game cooking there. Then plumbed in a propane line for a cast iron double burner. This can be used for turkey fryer, or blackened fish or steaks. You don't want that cloud of blue smoke in the kitchen. Close by is the chest deep freeze pretty much full of deer, ducks, geese, pheasant and walleyes and pike. Backup emergency 10k genny hooked up to the 200 amp power panel.I could pretty much survive there for two to three weeks until the radioactive cloud is gone. Oh yeah, there is a shower, office and small bedroom to catch a nap. That area heated and ac by one of those Amana Motel Units.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
