Posted by mark on January 11, 2009 at 17:36:42 from (172.164.251.77):
In Reply to: Drying hydraulic oil posted by Bret4207 on January 11, 2009 at 16:21:26:
Bret,
I have seen Hydraulic fluid be mud brown from water in it, with no apparent ill effects to the system. Not that I think it's OK....just an observation.
Many old tractors sit outside and rain will get past the shifter boots and down into the sump...that's where most of the water contamination comes from. If condensation was the culprit..we'd all have problems. Therefore I don't think condensation is your major culprit.
Does the fluid still look like it did when you installed it? Oil and water MOSTLY does not mix. If there is a lot of moisture present..it will turn milky when churned up by the pump/gears.
IF it were me.....and I had minute moisture accumulating in the valves and freezing them....I'd add some dry-gas (methyl alcohol) and see if that takes care of it. The alcohol absorbs the water and then it evaporates.
Like one person suggested, the water sinks to the bottom. One day before starting your tractor, crack the hydraulic reservoir drain and see if water runs out. If it does, let it run until oil begins to come. If it's just a half cup or so...then add some dry gas and see what happens.
You're going to have to get the water/moisture out of the valves regardless.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - New Hitches For Your Old Tractor - by Chris Pratt. For this article, we are going to make the irrational and unlikely assumption that you purchased an older tractor that is in tip top shape and needs no immediate repairs other than an oil change and a good bath. To the newcomer planning to restore the machine, this means you have everything you need for the moment (something to sit in the shop and just look at for awhile while you read the books). To the newcomer that wants to get out and use the machine for field work, you may have already hit a major roadblock. That is the dreaded "proprietary hitch". With the exception of the
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
