There is no "Pressure" switch. Fuel pressure sensors didn't come about until the returnless fuel system was developed. Fords do have an inertia switch that is a safety shut off in case the pump relay were to stick closed and a fuel line were severed in an accident. It takes a significant bump from another vehicle to cause it to open. Since the pump runs even when the truck won't start, that isn't your problem. One problem they did have back then on dual tank vehicles, and there was a recall (93S68) for it, was they would transfer fuel between the fuel tanks. The fix was install a check valve on each fuel pump in each tank and a new fuel pressure regulator. When the truck won't start, check for battery voltage on the coil primary feed from the ignition switch. Fords with EEC4 are the worlds easiest vehicles to hotwire. Run a wire from the battery to the coil positive and it will power up the ignition and engine control. I'm thinking you will find either a PCM problem, or a wiring issue. The fuel pump relay is controlled by the PCM, not at all by the ignition switch. The only time the relay will engage is during cranking, or when the PCM sees a tach signal (engine running). Look closely at the PCM relay and fuel pump relays. They are on the fender next to the starter relay. An O.E. fuel pump relay will be green. Look the wires over closely for shorts to power since the supply for the fuel pump and PCM are live at all times. Fords of that era have very durable and dependable PCM's, so check the wiring first.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
