Posted by NEsota on December 20, 2008 at 10:24:11 from (75.72.251.223):
In Reply to: The Metric System posted by John B. on December 19, 2008 at 17:45:15:
The more one works in the physical sciences, the more one sees the long term advantages and efficiencies of the metric system. President Jimmy Carter, a Chemical Engineer by education, made an effort to convert the U.S to the metric system. This was ambitious, but the short term pain of converting would have brought a lot of long term gain. Jimmy’s successor was not a believer in short term sacrifice for gain long term. He scraped the effort to convert. This may have helped the economy short term, as the conversion was not without some cost. We, (the U.S.) would be better able to compete in the world’s markets if our engineering, manufacturing and everything else were done in metric measurement.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
