Posted by Larry59 on December 03, 2008 at 20:09:50 from (4.245.0.88):
In Reply to: billonthefarm posted by Stan - Florida on December 03, 2008 at 18:15:37:
Bit cool here in MO. where I am at. Cold front drop down from up north this day. Brought some cold here and windy conditions around 3 pm. Talk of snow but did not happen and the ground here is snowless and a bit dry. Cleaned out my wood furnace yesterday again. So it is fired up tonight. Hope to save on electric bill here some. But every so often today. I have notice a light goes dim and bright. Had scanner on and no reports of accidents around. So not for sure what is going on. Did run my chickens in earlier. The wind was cold coming out of the north and that blows right inside the door opening for them. Don't have a lot of them but they are given me 8 to 9 fresh xlarge brown eggs each day in this cold. :) Worried some that I may not have cut enough wood for my outside furnace. Did not expect to be using it so soon. Have a good holiday coming. :)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
