Posted by Chas Fergie-30 on November 19, 2008 at 14:00:37 from (174.145.79.92):
Hi Connie,
I have the same set of Indusco offset discs model 201, that you have. Although you can slide the front gang and the rear gang independently and angle the set both left and right, there are a few combinations that work to help the discs pull straight. First, you should try to adjust the front and rear gang so that they don't cut in the same furrow. This helps offset the front gang pulling to the left by giving the rear gang some solid ground to pull to the right. Also, the more cut angle that you adjust the front gang to cut, the more down pressure you will need on the rear gang. This is accomplished by cranking the top adjustment to make it longer which allows the rear gang to contact the soil first. Here are pictures of my discs. Good luck and post your results.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
