Posted by Mark - IN. on October 13, 2008 at 19:44:15 from (64.12.117.74):
In Reply to: O.T. Skunks? posted by PatrickinTexas on October 13, 2008 at 07:24:19:
They are night creatures, like to come out as the sun's setting. Can't just an evening or two sit out there an hour or so with a beer or two to make it worth your time, and when he comes out, shoot him? I've done it a time or two. It works. Shove his carcus into the den, bury it.
I remember once had just broken my hand, it was sore and swelling. Sun was just going down, I wasn't happy, and out came a skunk. I grabbed a lever action Henry that couldn't hold with the broken hand, couldn't load with the broken hand, couldn't ratchet the lever with the broken hand, and shot half a$$ed with my left hand like a revolver, and missed. That skunk saw me and came charging at me. I had a rifle that couldn't hold to ratchet again and a charging skunk. I ran to the left, it ran to the left. I cut back to the right, it cut back to the right. That was one angry skunk. I ended up runnin and flippin over a fence and ran all the way to the house. I never saw a skunk do that before. I know can get vicious if corned, but this guy wasn't corned. He had the whole field, yard, woods, and the world, but he came after me. I figure he must've been rabid.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Machine Shops - by Curtis Von Fange. It is a story that repeats itself countless times. In the process of rebuilding a particular section of the tractor there is a broken part for which a replacement cannot be found. The parts houses find in their catalogue that it is unavailable. The dealerships call it a discontinued part. Salvage yards define it as hard to find or, even worse, rare. Everyone on the NET says, 'what is it?' But don�t despair there is another avenue that can be used to get that piece repaired. The local mach
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
