Posted by casey in ky on September 12, 2008 at 17:06:11 from (76.8.179.60):
I asked the question a few months back about what brand of windows to get and well, I settled on Polaris Thermawelds. They seem like a real good window but I"ve got some questions on installing them as I"ve never done the replacement window thing before and of course no installation instructions came with the things.
Each window came with a small strip of vinyl(similar to whats ont he bottom of screen door, just thicker and not as flexible) that looks like it slides in at the bottom of the window. I"m assuming that where it goes because it would appear to cover the angled window seal. If this is not correct, would someone please enlighten me.
Second, should I have some sort of spacer system for the top. I would swear that the windows will be about a half an inch to short, but I had the dealer come and measure them. I can always put a peice of trim outside around the top if it is to short, but that would be a pain. Or does the strip I referred to at first make a difference in the height??
And last, the windows have 3 pre-drilled holes on the outside of the frame. On the inside of the window, I only have access to the bottom holes. They are pre drilled all the way thru and have a place for the head to be countersunk. The middle and top screw do not unless its under the track somewhere, but I don"t think that these could be took aprt in any way. Any suggestions or help would be great.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Revival of a John Deere Combine - by The Red, John Fritz. For several years I had been driving by a farm house on the west side of Indianapolis that had a John Deere combine parked in high weeds in a lot behind the house. The gentleman no longer farmed because the entire area was developed with housing and light industry. I had stopped several times and knocked on the door but no one would answer. My curiosity was up and I wanted to contact the owner. I wanted to see what he planned to do with the combine.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
