Posted by NCWayne on August 14, 2008 at 12:24:51 from (166.82.164.236):
In Reply to: drillin out roll pin posted by MSS3020 on August 14, 2008 at 08:24:37:
Like the other posts have said a roll pin is HARD so drilling, especially by hand, isn"t a real option. The biggest problem is that even if the hardness didn"t dull the bit the split down the side will more than likely cause the bit to hang up and twist off. Based on what your saying and I"m understanding, the big problem here is your not wanting to remove a bushing just to get it out. Without knowing the size of the roll pin or the bushing, I"ll make a suggestion that may or may not work for you depending on the sizes and accessibility of the ID of the bushing. If the roll pin is big enough in diameter to have a decent size hole in the center get a bit that size and use it to drill a hole down through the bushing. This will give you a hole to use as a guide. Then if the ID of the bushing is large enough to get to it use a burr to enlarge the hole enough from inside the bushing for the roll pin to drive on through. The hole in the side of the bushing should never make a difference but it"ll allow the pin to come out without removing the bushing completely. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
