Posted by Big M on August 01, 2008 at 05:39:29 from (63.160.30.120):
In Reply to: hyd. cylinder posted by farmall504 on August 01, 2008 at 03:49:51:
Push the shaft all the way into the tube, remove the fitting from the tube that supplies the oil to the cylinder. Look into the hole and you may see a small wire ring in a groove on the shaft. With a pocket screwdriver roll the wire ring into the deeper groove in the end of the shaft and then try and remove the shaft from the tube. When you replace the dirt seal and o-rings, just reverse the procedure. Roll the wire ring out of the deep groove onto the shallow grove. If you go too far and it jumps off the end, just fish it out and try again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The River Tractor - by Charlie English Jr.. This is a 4010 John Deere that was used to farm on the Diamond Island which is in the Ohio River about 15 miles southwest of Evansville, Indiana. About ten years ago, this tractor was parked close to the bank as the river was washing the bank of the island away.
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
