Posted by Mike (WA) on July 24, 2008 at 08:56:27 from (69.10.198.224):
In Reply to: Pea-ing PICS!! posted by bradk on July 23, 2008 at 17:51:23:
Lots of peas in western Washington. Dad told of working on a viner in the '30's- they cut and hauled the vines to a stationary viner which moved from farm to farm, much like the old threshing machines. Crew followed it. Dad was pitching the peas into the machine with a pitchfork, along with another guy. A favorite trick when guys got tired was to throw too much in and "slug" the machine and break the shear pin, then everything gets shut down while the clean it out. Wagons backing up, etc., big PITA. Farmer at one place told them he'd give them a 25 cent an hour bonus if they got through the 2 or 3 days at his place without shearing a pin. Pretty big deal, because they were only getting 50 cents an hour. Things went well until right near the end of the job, and the machine just quit. Farmer came over, found that it wasn't plugged, retreived the shear pin and said, "My fault, boys, the shear pin just wore through. I should have changed it every morning. Your bonus is still good." Dad always remembered that guy fondly.
Fast forward to the '60's- mobile viners now, pulled by a fleet of Fordson Major tractors. Running those rigs was the primo summer job- the growers and "good ole boys" kids always got them, I never could, so I bucked bales.
Fast forward to today- self propelled "pod strippers" with air conditioned cabs. They run ads for operators in the newspaper all the time- can't seem to get enough folks to keep them all going.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
