|
Tractor Talk Discussion Board |
Re: Open Center vs. Closed Center Hydralics
[ View Follow Ups ] [ Post Followup ] [ Return to Tractor Talk Discussion Board ]
Posted by herv� on February 11, 2000 at 10:40:36 from (164.138.75.164):
In Reply to: Open Center vs. Closed Center Hydralics posted by Greg on February 11, 2000 at 10:18:41:
hello, i try to make a simple response on a big subject. On a tractor you can have the two types. With an open center, the pump is a gear pump, so the flow rate is always the same. When a remote valve on the tractor is in the neutral position, the valve receive the flow and return it directly to the tank with no pressure.
With a closed center, the flow can't travel the the remote valve on the neutral position so the pressure increases. With an axial pistons pump, the plate which drive the pistons came at a right angle with the drive shaftwhen the pressure increases, so there is no stroke for the the pistons, so you don't have flow. The most important advantage is to use one pump for all the function of the tractor. I hope this help you. If I made some mistakes, excuse me but my english is a little bit difficult for a french man like me. Herv�
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: Lead Substitutes - by Mike Schordine. Lead was oriinally added to gasoline as an upper cylinder lubricant. It lubes the valves and seats. If you rebuild the motor, you could use hardened seats and valves, and unleaded fuel. But if your old tractor runs good, a simple lead substitute added to the gas is a perfectly reasonable solution. And, if you are like me, your tractor is under cover, but it sits outside. So with every temperature change, the humidity in the air collects in the fuel tank, in the form of water.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
