Posted by Lanse on June 27, 2008 at 18:38:11 from (64.12.117.74):
In Reply to: C bearings posted by Lanse on June 27, 2008 at 14:20:03:
I've learned that one the hard way, dick :-) lol. Seriously, all i have hooked up right now are the 1 and 4 rods (and obvisly the mains). Jim, i checked again and sure enough there was about a pop can thickness difference with the bearing and the cap, which i filed away.
I torqued one bolt up and went to the second one, when i tried to spin the engine. It spun really easy, and i thought i'd found the rainbow's end here, but when i put the second one in it would'nt spin at all. Should i only shim the second bolt's side of the cap or what????
Dick, i'd like to thank you for all your help and patience here, i know you could do this stuff with your eyes closed, so thanks for helping me along
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - by Teri Burkholder. The View from the Garage - Never a doubt, everything on our farm is a learning experience. I've been working very hard to get our two rundown Farmall A's sanded, primed , bondo�d, fiberglassed and painted before our big local tractor show called the Tulip Festival. My husband Ben came in the garage one rainy day to see if he could "help". Well if you knew Ben you wouldn't want him anywhere near your spray gun, fiberglass or bondo! So I pulled out the 2 old yucky looking magne
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
