Posted by DickL on June 28, 2008 at 06:23:44 from (76.76.33.112):
In Reply to: Re: Sorry Back posted by Lanse on June 28, 2008 at 05:18:14:
The shims on both sides (must be the same thickness) or you will not only have a pinching condition but it puts the center of the bearing off center. I bought a 1923 Chevy from a guy that had the engine rebuilt in a restoration shop. When he got the engine back his farther inlaw who was a auto mechanic, wanted to check the work so they pulled the pan and removed the rod caps. (poured babbitt bearings) The fellow put it back together later. When I bought it he said he didn't understand why after he reassembled it the engine was locked up. After I got it home I pulled the pan and dropped the rod caps and found that the shims had been put back in with more on one side than the other. Checking with plastigage I found that each rod had the correct shims and when they were put back with the same thickness on both sides the engine was no longer locked up. Never torque one bolt all the way before tightening the other. I always bring both to 20 pounds and the take them both to torque in three or four steps. A good job always takes time. More time than you will expect even after you have done many. Used engines seem never to be the same even though they look the same to the eye.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Tractor's Point of View - by John Manley. I began my life on August 3,1941. I was actually built at different times and days but I was officially an M Farmall on August 3.I was real nice and shiny. That�s me, in the old picture, third from the left. I was loaded on that train and sent to a little town in South Carolina. I didn�t get to see much of that town. I was moved off the train fast and on to the dealer�s
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
