jose bagge said: (quoted from post at 08:01:34 06/19/08) Ya know, I get the impression that you as well as a lot of the other dirt farmers on this board have a real problem with the fact that this hay is bought for HORSES....if it was being fed to guinea pigs, alpacas, or elephants you'd have less of a problem with it. What if this was show cattle or show goats?
I think a good mare kicked a bunch of you in the a$$ when you were young and created a phobia. Horses are LIVESTOCK just like show cattle. We make a living (at least partially) sellin' 'em, so it's not a matter of this " well, if they can afford horses" BS.
YOUR hobby/business is is gas powered, and an inordinate amount of time on this board is spent complaining about gas prices. THEIR hobby/ business is hay powered- why can't they do the same? IN THIS CASE, YOU ARE THE ARABS!
welp i dont think its so much the horses these guys have a problem with . its the SORRY A horse owners :roll:
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.